※本網站所提供產品規格內容如有變更,恕不另行通知。實際請以各廠牌官方最新公告資訊為主。
LCD Panel | Pixels |
1,024,000 (1280 x 800) pixels |
Light Output*1 *2 |
3,800 lm |
Time until light output declines to 50%*3 |
20,000 hours (NORMAL/QUIET)/24,000 hours (ECO) |
Resolution |
WXGA (1280 x 800 pixels) |
Digital Zoom Extender *4 |
Throw ratio: 0.43–0.54:1*5 (Corresponding value) |
Power Consumption*9 | Maximumpower consumption |
230 W |
Power Consumption*9 | On-modepower consumption (Light Power) |
[NORMAL]: 205 W (100–240 V), 195 W (200–240 V)[ECO]: 155 W (100–240 V), 145 W (200–240 V)[QUIET]: 150 W (100–240 V), 145 W (200–240 V) |
Note |
*1 Measurement, measuring conditions, and method of notation all comply with ISO/IEC21118: 2020 international standards. Value is average of all products when shipped. *2When [PICTURE MODE] is set to [DYNAMIC], [LIGHT POWER] is set to [NORMAL],[DAYLIGHT VIEW] isset to [OFF], and [AUTO POWER SAVE] is set to [OFF]. *3 Around thistime, light output will have decreased to approximately 50 % of its original level ([PICTUREMODE]: [DYNAMIC], [DYNAMIC CONTRAST] set to [2], temperature 30 °C (86 °F), elevation700 m (2,297 ft) with0.15 mg/m3 of particulate matter). Estimated time until light outputdeclines to 50 % varies depending on environment. *4 Resolution decreases when usingthis function. V/H Keystone Correction and curved-screen correction are not availablewhen using this function, and range ofcorner adjustment is limited. *5 When Digital ZoomExtender is set to 80 %. *6 4K signals are converted to the projector's resolution uponprojection. *7 Depending on the connected CEC command-compatible device, the linkcontrol may not operate normally. *8 On standby, powersupply is available with QuickStartup set to ON or Power Management set to Ready. *9 Measurement, measuringconditions, and method of notation all comply with ISO/IEC 21118: 2020 internationalstandards. On-mode power consumption measured at 25 °C (77 °F) operatingtemperatureat an altitude of 700 m (2,297 ft). *10 Filter cleaning cycle varies depending onenvironment. Filter can be washed and reused up to two times. Filter cleaning cycle:20,000 hours (under dust conditions of 0.08 mg/m3), 10,000 hours (under dustconditions of 0.15 mg/m3).*11 Average value. May diff er depending on the actual unit.*12 Light output is limited at operating temperatures higher than 30 °C (86 °F), andprojectors cannot be operated at altitudes higher than 2,700 m (8,858 ft) above sea level.When optional AJ-WM50 Series Wireless Moduleis attached, operating temperature rangebecomes 0–40 °C (32–104 °F). *13 When using Presenter Light Software, images areprojected with 1280 x 800 dots or 1024 x 768 dots onto the screen. Also, your PC displayresolution may be forcibly changed, and audio playback disrupted orbecome noisy, whileimages and sound are being transmitted. *14 When using the Wireless Projector app,display resolution diff ers depending on your iOS/Android™ device and the display device.The maximum supported display resolution is WXGA (1280 x 800). |
Projector type |
LCD projectors |
LCD Panel | Panel Size |
16.3 mm (0.64 in) diagonal (16:10 aspect ratio) |
Light Source |
Laser diodes |
Contrast Ratio*1 |
3,000,000:1 (Full On/Full Off ) (When [PICTURE MODE] is set to [DYNAMIC] and [DYNAMICCONTRAST] is set to [1].) |
Screen Size (Diagonal) |
1.27–2.67 m (50–105 in), 16:10 aspect ratio |
Center-to-corner zone ratio*1 |
85 % |
Lens |
Fixed zoom, manual focus lens, F = 1.8, f = 6.08 mm,throw ratio: 0.43:1 (Projectiondistance: 0.73 m [2.40 ft] for 80-inch image) |
Keystone Correction Range |
Vertical: ±15 ° (Auto, Manual), Horizontal: ±15 ° (Manual) |
Terminals | HDMI 1/2 IN |
HDMI 19-pin x 2 (Compatible with HDCP 1.4, Deep Color, 4K/30p*6 signal input), CECsupported*7 |
Terminals | Computer 1 In |
D-sub 15-pin (female) x 1 (RGB/YPBPR/YCBCR) |
Terminals | Computer 2 In |
D-sub 15-pin (female) x 1 (RGB/YPBPR/YCBCR) |
Terminals | AUDIO 1/2 IN |
M3 stereo mini-jack x 2 |
Terminals | Serial In |
D-sub 9-pin (female) x 1 for computer control (RS-232C compliant) |
Terminals | LAN |
RJ-45 x 1 for network control, 10Base-T, 100Base-TX |
Terminals | USB(VIEWER/WIRELESS/DCOUT) |
USB connector (Type A) x 1 for Memory Viewer function, optional AJ-WM50 Series WirelessModule, power supply (DC 5 V, maximum 2 A*8) |
Power Supply |
AC 100 V–240 V, 50/60 Hz |
Built in Speaker |
10 W monaural |
Filter*10 |
Included (Estimated maintenance time: approx. 20,000 hours) |
Operation noise*1 |
35 dB (NORMAL/ECO), 24 dB (QUIET) |
Dimensions (W x H x D) |
349 mm x 138 mm x 370 mm (13 3/4˝ x 5 7/16˝ x 14 9/16˝ ) (with feet at shortestposition) |
Weight with supplied lens*11 |
Approx. 4.9 kg (10.8 lbs) |
Operating Environment |
Operating temperature: 0–45 °C (32–113 °F)*12, operating humidity: 20–80 % (nocondensation) |
Applicable Software |
Multi Monitoring & Control Software, Projector Network Setup Software, Logo TransferSoftware, Presenter Light Software for Windows®*13, Wireless Projector App foriOS/Android™*14 |
Terminals | Audio Out |
M3 stereo mini-jack x 1 |
Protocol versions |
IPv4 |
Control function via LAN |
PJLink™ [Class 2], Crestron Connected™, AMX Device Discovery |
運送說明
1.本網站訂購之商品將於訂單轉出後統一由服務人員與您聯繫配送,本公司配合物流如下:
*神行貨運。
*台快貨運。
*宅急便物流。
*便利帶物流。
*郵局。
*宏程自行配送。
**商品如無特殊情況( 遇原廠缺貨、客戶延期.....等)將於2個工作日內出貨。配送時間依照各地物流配達為主。如需詢問可透過官方LINE:@daka1788 或電話 02-23942890 詢問配送進度。
2.詳細配送說明
(1)商品如標示免運費。則消費者毋須負擔運費。
(2)如遇偏遠地區,將依地區收取偏遠運費。
(3)不提供舊機拆卸安裝與回收服務
(4)詳細配送條件將於訂單確認時由專員與您核對。
(6)如遇無電梯之樓層,將依樓層收取樓層費。
(7)貨運僅配送額外服務需求將依現場報價收取。
3.影音產品配送
(1)商品將於訂單付款完成後2個工作天內出貨。
(2)商品將依據大小、地區,調整配送方式,恕不可指定配送商
提醒您。於宏程購物網購買之商品必須於網頁申請退換貨:點我前往(電話或口頭告知皆不成立)
依照消費者保護法規定,消費者均享有產品到貨7天猶豫期之權益(注意!猶豫期非試用期),但提醒您,商品退貨時必須是全新狀態且包裝完整,所有內容物必須回復原狀,亦即必須回復至您收到商品時的原始狀態 (包含主機、附件、內外包裝、隨機文件、贈品等),若為部分商品退貨則針對您已使用或保留之商品應另以市價計價,否則將影響您退貨的權限。
*7天猶豫期(非試用期)內進行商品退換貨時,應負有回復原狀之義務。
*退換貨商品必須是全新商品,商品與盒裝外觀不得有刮傷、破損、受潮、塗寫文字,且必須保有相關配件(保護袋、配件包裝、保麗龍、贈品、所附文件...等)之完整性。
*猶豫期內請保留原「運送外箱」,勿讓物流商或貨運公司收走,以便退換貨返還時保護商品使用。
*另投影機,顯示器、音響除產品本身故障或瑕疵外,一經使用將會影響退貨權限。
<<特殊情況無法退貨>>
1. 商品因消費者個人因素需延後配送超過訂單日7天以上。經告知為保留商品無法退貨後,即不允退貨。
2. 商品原始外包裝與包材(紙箱、保麗龍、保護材….等)遺失、損毀或非使用原始包材,因無法確保物流配送狀況,則不允退貨。
3. 經原廠判定為人為損壞商品,因商品已無法復原原始狀態,不允退貨。
<<換貨流程>>
1. 商品經使用者開封使用後,如商品本身瑕疵,將通知原廠服務站到府檢測。
2. 原廠確認新品不良後,始可換貨。
3. 非商品本身瑕疵換貨,消費者如無法復原原始商品,須負擔整新費用(依照使用程度逐項收取)。
4. 非新品猶豫期間內提出申請換貨(商品送達後7日後),將由原廠服務站與消費者說明後續處理。
<<特別說明>>
1. 大型商品退貨原因如為商品異常,將請原廠指定服務單位到府鑑定商品,請於退貨時一併將檢測單據附上,如無法附上或拒絕原廠指定服務單位到府檢測將視為良品退貨,並依照使用程度逐項收取費用。
2. 大型商品回收時將於回收地點現場基本商品狀況確認,如消費者拒絕人員確認或無法於取回地點確認,經人員回報後,則不允回收商品並拒絕退貨。
3. 配送或回收商品僅有一次免費派遣,如因消費者因素造成二派情況,產生費用將由消費者支付。
4. 配送人員安裝商品,視同消費者使用商品,如對商品有疑慮,消費者有權選擇不安裝
5. 本公司收到您下單(要約)後,仍需確認交易條件正確、供貨商品有庫存或服務可提供。如有無法接受訂單之異常情形,或您下單後未能完成正常付款,應視為訂單(買賣契約)全部自始不成立或失效,本公司得於合理期間內通知說明拒絕接受訂單。請您重新依需求下單訂購。